Stainless steel Telescopic Camera Mast Pole 3m Manual Tripod Mast
Discription:
1. Okaf telescopic mast widely applied to PTZ camera, dome CCTV camera, led emergency lighting field. Tubes are made of high tensile military degree stainless steel and all are heat-treated Which again corrosion, rust and acid rain. So the mast life time is longer.
2. The stainless steel telescopic mast is light weight. It is very portable. You could easily take it out and use it on the vehicle or ground.
3. The telescopic pole is manual lifting. There are two sections. When you When you loosen the screw, you could control the Pole raised or down. When you tighten the screw, you could fixed height of the mast.
4. The manual telescopic is simple design. It doesn’t need many accessories. Only need tripod and some screws. The accessories could be provided. With the simple design, the mast is very easy to operate. You can finish install it in a minute.
Technical data of the telescopic mast:
| Lifting method |
Manual |
| Extended height |
3 meters (can be customized) |
| Retracted height |
1200mm |
| Number of Section |
Section 2 |
| Horizontal and vertical rotation speed |
6r/min |
| The wind resistance |
40Km/h |
| The largest load |
10 KG |
| Material |
High tensile stainless steel |
Environmental adaptability:
| project |
Test conditions |
| The wind resistance |
8 wind working normally 12 wind does not destroy).3.13.13 GJB74A - 1998 |
| Low temperature storage |
-55° |
| Work in low temperature |
-40° |
| High temperature storage |
70 degrees |
| High temperature work |
65 degrees |
| Wet degree |
Less than 90% (25 ° temperature) |
| Drench the rain |
The duration of 6mm/min was 1h |
| Corrosion protection |
Refer to gjb150.11a-2009 standard test |
| Sand dust |
Refer to GJB150.12.1986 standard test |
| The sun's radiation |
Refer to GJB150.7.1986 standard test |
Packing information:
All the telescopic masts are well packed with standard export wood box. Never worry about goods would be damaged during the shipment.
